Difficult fires on a cold engine 1.9 jtdm

[mike87]

Hello

I have a problem with the launching in the cold engineu at low temperatures. Namely, the nagrzewam candles (waiting ok 10-15 seconds after the light goes out, the lights). The motor spins, grabs for a split second but not odpali. After three attempts, auto fires. Then an error pops up "Motor control failure system". Auto goes normally. I have replaced the spark plugs, EGR zaślepiłem-maps have been changed, so as not to jumping bug. I already do not know what it might be. Mechanic concludes that these may be flowing injectors, but doesn't throw the black smoke. Can everything she sits on DPF?

What do you think? Have any of You a similar case?
At temperatures above 7-8 degrees in the black, auto fires normally.

PS. I have for sale a used but serviceable glow plugs

---

› Więcej...: Difficult fires on a cold engine 1.9 jtdm

[Fisz]

According to me to check:
-CR
-injections
-compression
-glow plug relay

[george11]

First of all:
---I don't understand, are you waiting for 15s after all-round? What grzejesz? You should start circulating immediately as soon as it goes off light is heating the candles.
After the second
---How to pipe while trying to run extracts in August no smoke, nor white, nor black, etc is simply engine not getting fuel to the engine lit must be met, and so the starter motor must circulating with the appropriate speed and voltage should not then go down to below załozonej value.
proposes to pay for the repair of starter!!!!!
PZD.

[Vanilia]

I do not understand, are you waiting for 15s after all-round? What grzejesz? You should start circulating immediately as soon as it goes off light is heating the candles.

PZD.

I also think so. How to wait after heating even while my folded also do not want to fire up.

[bocian]

even in the "stupid" for some statement unless it is a description that the launch shortly after the candle lights shuts off
But what if you will

[maciey]

In dieslach with push button START/STOP when the light goes out, the glow plug lights, auto fires almost immediately. And so too should light up on the ignition switch, and not wait

[100P]

I always burned immediately after the communication of the computerand that everything is OK. If engine weakly turns you have to see first the battery and plug or not pośniedziały ew, tighten properly. weak batteries is the cause of most problems with launching.
If the Starter spins just fine and the engine still does not fires it to see if IT not let go CR pump somewhere sideways. broken pump cr may give such symptoms.

[george11]

OK give us the entire injection system, wgrajcie a new program and at the end it turns out that the Starter a little slower krecił and for bużo power ...

PZD.